On 2006-12-17, Stan <SPAM_FOILER@some.domain> wrote:
[color=blue]
> On Sun, 17 Dec 2006 12:35:37 UTC, Brian <bandj@o2.co.uk> opined:[color=green]
>> The PAP2 responds to **** codes. You can get IP address, netmask, dhcp
>> status etc but cannot alter them through the IVR because it asks for a
>> password. Is that correct? The ATA is functional but not in the way you
>> want it to be. If you manage to access it with a browser the password
>> problem will presumably arise again.[/color]
>
> I am snowed by the terminology: if IVR is the disemboded voice from
> the PAP2T, that is NOT correct. I CAN set the IP address, DHCP state,
> Gateway address, and subnet mask through the telephone set and the
> **** codes. I cannot access the PAP2T's configuration screens through
> the browser with URL <http://192.168.1.150>, because it times out.
> There is no request for a password.[/color]

I was working on what you said in your first post:
[color=blue]
> I tried to reset the device using the codes "****" + "73738#"; that
> brings up a login dialog with the recorded voice, asking for my
> password.[/color]

and
[color=blue]
> After
> that, even the "****" code doesn't work (no feedback tone in the
> handset receiver), so that the device is totally dead in the water.[/color]
[color=blue][color=green]
>> The ATA, computer and router are all on the same subnet but web pages on
>> the ATA won't display. Could be the web server is disabled. I think I'm
>> running short on ideas here.[/color]
>
> The web server is in the PAP2T; I know of no way to enable it or
> disable it.[/color]

****7932#

Brian.