On Sun, 17 Dec 2006 12:35:37 UTC, Brian <bandj@o2.co.uk> opined:[color=blue]
> On 2006-12-17, Stan <SPAM_FOILER@some.domain> wrote:
>[color=green]
> > On Sun, 17 Dec 2006 00:59:44 UTC, Brian <bandj@o2.co.uk> opined:[color=darkred]
> >> Change the phone and connecting cable? Yes, I know it has worked
> >> previously but......[/color]
> >
> > The cable is good: the Ethernet LED flickers with LAN traffic.
> > The phone is good: I can check and set the settings of the device.[/color]
>
> The PAP2 responds to **** codes. You can get IP address, netmask, dhcp
> status etc but cannot alter them through the IVR because it asks for a
> password. Is that correct? The ATA is functional but not in the way you
> want it to be. If you manage to access it with a browser the password
> problem will presumably arise again.[/color]

I am snowed by the terminology: if IVR is the disemboded voice from
the PAP2T, that is NOT correct. I CAN set the IP address, DHCP state,
Gateway address, and subnet mask through the telephone set and the
**** codes. I cannot access the PAP2T's configuration screens through
the browser with URL <http://192.168.1.150>, because it times out.
There is no request for a password.[color=blue]
>
> The ATA, computer and router are all on the same subnet but web pages on
> the ATA won't display. Could be the web server is disabled. I think I'm
> running short on ideas here.[/color]

The web server is in the PAP2T; I know of no way to enable it or
disable it.
[color=blue]
> Brian.[/color]