Turandot wrote:[color=blue]
> I bought a SPA-3000, setup line1 with voipstunt, connected a Philips
> cordless phone to the phone port, linked the line port to BT socket. When I
> call my BT number, the phone doesn't ring. I used the spa-3000 monitor
> software found on the net and it showed line1 is registered, PSTN not
> registered, voltage 51V.
>
> VoIP-To-PSTN Gateway Setup
> VoIP-To-PSTN Gateway Enable: yes
> VoIP Caller Auth Method: none
> VoIP PIN Max Retry: 3
> One Stage Dialing: yeso
> Line 1 VoIP Caller DP: 1
> VoIP Caller Default DP: 1
> Line 1 Fallback DP: none
>
> PSTN-To-VoIP Gateway Setup
> PSTN-To-VoIP Gateway Enable: yes
> PSTN Caller Auth Method: none
> PSTN Ring Thru Line 1: yes
>
> FXO Timer Values (sec)
> VoIP Answer Delay: 0
> VoIP PIN Digit Timeout: 10
> PSTN Answer Delay: 16
> PSTN PIN Digit Timeout: 10
> PSTN-To-VoIP Call Max Dur: 0
> PSTN Ring Thru Delay:1
> VoIP-To-PSTN Call Max Dur:0
> PSTN Ring Thru CWT Delay: 3
> VoIP DLG Refresh Intvl: 0
> PSTN Ring Timeout: 5
> PSTN Dialing Delay: 1
> PSTN Dial Digit Len: .1/.1
>
> I increased the Line-In-Use Voltage to 70, same results. I tried to setup
> PSTN as sipgate, PSTN showed registered, but still no ring when I call the
> BT no. When I setup Line1 as my sipgate no., the phone rings when I call the
> sipgate no. Where else should I look? Is the ATA faulty? Thx.
>
>[/color]
I assume that you are using a lead from the ata to the phone that has a
ringing capacitor in it?